HOW TO: Configure Modbus TCP to Modbus RTU Bridge using ConnectPort X2/X4 Gateways and Series 1 XBee Modules

First make sure the Xbee nodes have joined with the ConnectPort X2/X4 802.15.4 Gateway:

User-added image

Once joined, ensure the XBee node settings are configured with the same PAN ID as the ConnectPort X2/X4 Gateway, the proper DL/DH setting on the XBee node(s) are  pointing to that of the ConnectPort X2 and the MY setting is configured for 0xffff to disable 16 bit addressing (64 bit addressing only with Modbus)  These settings can be configured from the web interface of the Gateway:

Gateway Configuration:

User-added image

Advanced:

User-added image

XBee Node Configuration:

User-added image

Advanced:

User-added image

Next configure the Modbus settings from the Industrial Automation menu on the gateway:

Industrial Automation Configuration:

Configure a name for the table:

User-added image

Configure the protocol/port:

User-added image

User-added image

Configure the Industrial Automation table:

User-added image

User-added image

Example completed table:

User-added image

Unit should be rebooted to implement changes.

Check Connections:

Example connections seen when Modbus application is connected and running:

User-added image
Last updated: Jun 23, 2019

Recently Viewed

No recently viewed articles

Did you find this article helpful?