Home/Support/Support Forum/Xbee S3B 900HP change firmware from 200k to 10k datarate
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Xbee S3B 900HP change firmware from 200k to 10k datarate

0 votes
I have XBP9B-DMST-002 900Mhz modules which has Digi Mesh 200k firmware on it. I was trying to put 10k firmware on this. (i believe hardware is essentially the same)

DMST tab does not have any other option than 200k, and When i choose XBP9b DPST 10k as product family it throws following error.

Error Updating Radio module
- Checking for bootloader updates... [OK]
- Getting device information... [OK]
- Entering programming mode... [ERROR]
Could not enter programming mode. > Could not reset the module.

Is there any way at all to program these modules for 10k data rate ?
asked Dec 30, 2020 in XCTU by legendkiller82 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to use the XBP9B-DP XBee PRO 900HP 10K option.
answered Dec 30, 2020 by mvut Veteran of the Digi Community (15,515 points)
thanks for the quick reply ! but i did choose that option. that's when i got the said error :

" Could not enter programming mode > Could not reset the module ". then it 'Recovers' the module to normal operation.
i am using a Funduino Xbee usb adapter (FT232RL based)