Home/Support/Support Forum/Sleep Mode of Xbee 3 Zigbee 3 RF
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Sleep Mode of Xbee 3 Zigbee 3 RF

0 votes
Hey everybody!

I am working with an XBEE 3 Zigbee 3 RF with a SMT Grove development board and I would like to know if I can put my xbee into sleep mode (so no RF data transmission) while at the same time being able to receive data, from a sensor which sends data in the i2c bus, and store them in flash memory.

Thank you in advance!
asked Oct 5, 2020 in XBee3 ZigBee by manos New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
No, that is not possible.
answered Oct 5, 2020 by mvut Veteran of the Digi Community (15,515 points)
Thanks for your response!

I was kind of guessing that, I mean from what I have read in the user guide, but I hoped there was some kind of partial/light sleep with which I choose what is idle and what is in sleep mode...

Well if that can't happen then that's it...Thanks again!