Home/Support/Support Forum/Xbee S2C RPSMA Antenna Problem
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Xbee S2C RPSMA Antenna Problem

0 votes
Recently I bought 3 Programmable Xbee from mouser but there is problem with these modules. Sometimes it connects to PC, sometimes not. Can anyone help me with this issue and i found that there is short between signal line and ground of the RPSMA connector.
asked Apr 5, 2017 in ZigBee PRO Featureset (and legacy ZNet 2.5) by santosh_funambolo New to the Community (0 points)
recategorized Apr 7, 2017 by mvut

Please log in or register to answer this question.

1 Answer

0 votes
What interface board are you using to connect the XBee to PC?
answered Apr 5, 2017 by DystopianFerret Veteran of the Digi Community (368 points)
Xbee Grove Dev. Bd
Is the device configured as an End device?

What is the full part number of the module in question?
I'm having the same problem. I'm using a Xbee USB Adapter V2.1 from www.DFRobot.com


Thank you!
Gerardo and Funanbolo,

If this is the S2C module with the Zigbee firmware version installed, you enable the end device function by enable the sleep function (SM).

Digi Support