Home/Support/Support Forum/Correct cable to use between Juniper device and TS8?
New and improved user forum site coming soon
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Correct cable to use between Juniper device and TS8?

0 votes
We have a variety of Juniper devices. All of them ship with a piece of Cat 5e and a modular to DB9 adapter for console access (which works fine from a laptop).

For a few of the Junipers, we bought a couple of TS 8s so we could get to the console (over a different network, before you ask :-)).

What cable do I need? Straight through Ethernet doesn't seem to do the trick ASSUMING I have the port on the Digi set correctly. Currently set for "Console Management" in the GUI and 9600 8-N-1 (default, which is right for the Juniper end).

So do I need a different cable (an Ethernet crossover didn't work either) or am I set wrong on the TS8 end? Network part works and I can get in via SSH which will be the usual method.
asked Jan 13, 2016 in Portserver TS by plaws New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
It is my understanding Juniper consoles use the same pin-outs as Cisco:

answered Jan 14, 2016 by userid0 Veteran of the Digi Community (2,158 points)