Home/Support/Support Forum/how can I command IBxCR and setup memory banks?
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

how can I command IBxCR and setup memory banks?

0 votes
asked Sep 26, 2013 in Rabbit by AISWARYA RAJ New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Hello, It seems like you want to use external interface on the module through the Auxiliary I/O Bus?

By using WrPortI() you can set the internal registers.
For more information on this please check Dynamic C function reference manual.

And also check processor reference manual to know more about what are the steps you need to follow to use Auxiliary I/O Bus.

answered Sep 27, 2013 by cpigilam Veteran of the Digi Community (655 points)
Is the following command correct?
---for setting up I/O bank 2?
Actually this register is ,to set wait state and read or write strobe.
Please check the processor's reference manual page 263 for more info on the IB2CR bits.

can you provide me the commands to interface an fpga to RCM4000?
What should I do for this?
I have set SPCR register.after that what should I  do to read data from external I/O?
pls provide sample programs...