Home/Support/Support Forum/Digimesh associate behavior?
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Digimesh associate behavior?

0 votes

I am using Series 1 modules with the DigiMesh firmware in api mode (1 node, 1 coordinator). I have a microcontroller connected to the Xbee module, which resets the module upon boot.

The AI command always succeeds immediately. Is that normal? The ASSOC LED is always off - under which conditions should it light up when using DigiMesh?

After boot (and a successful AI command), I resolve the address of the coordinator. This step sometimes fails/takes 10-20 seconds to succeed. Why, if association is successful?

asked Jul 16, 2013 in DigiMesh Proprietary Mesh Networking by arnuschky New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
I realized that I can't fnd the AI command in the DigiMesh module's command reference. Does this mean that it's not supported?
answered Jul 16, 2013 by arnuschky New to the Community (2 points)